Kamco Power Flush FX2 is designed for use with Clearflow power flushing pumps, and is the flushing liquid to choose for the most rapid and effective results. It is a vigorous 'one shot' flushing and descaling liquid which starts to work immediately upon addition to the system. The Neutralising Crystals are added to the CLEARFLOW® tank after the final power flush 'dump' (when water leaving the dump hose is crystal clear) and circulated briefly to ensure neutralisation of any residues after use of Power Flush FX2.
Pack contains x1 carton of 4 x 2.5 litre FX2 and x4 tubes of Neutralising Crystals. Sufficient to flush four average dwellings (does not include inhibitor).
Power Flush FX2 enables heating engineers to thoroughly cleanse a heating system in just one visit, a significant benefit when so many households have both partners working full time.
When using Power Flush FX2 there is normally no need for a prior visit to pre-treat the system with flushing chemicals several days before the power flush, saving on expense and inconvenience.
Power Flush FX2 rapidly dissolves and mobilises the rust, sludge and corrosion deposits which accumulate in systems as a result of gradual decay, whether from corrosion as a result of bad design and air ingress, or lack of an effective corrosion inhibitor.
Removal of these deposits can cure or prevent circulation problems such as completely or partially cold radiators, frequent circulating pump failure and boiler noises caused by debris accumulating in the heat exchanger.
Neutralising Crystals are added to the Clearflow® tank after the final power flush 'dump' (when water leaving the dump hose is crystal clear) and circulated briefly to ensure neutralisation of any residues after use of Power Flush FX2.
To prevent future corrosion of system, add SYSTEMSAFE-DM scale and corrosion inhibitor to Clearflow tank and circulate through system for a further 5 minutes before disconnection. Use one litre per 100 litres system water content, or 1% dosage rate by volume.
CAUTION: Power Flush FX2 is acidic and, therefore, suitable protective clothing, gloves and goggles should be worn.
When using any acid, there is a possibility of flammable hydrogen gas being evolved, and the working area should be well ventilated. Avoid smoking nearby, or any other means of ignition.
Don’t forget once you have purchased and received your product, leave a "Customer Review" and share your thoughts with others.
Please note that delivery of this product outside of the UK mainland may incur and additional postage charge. Please contact the sales team to be advised.